Microsoft Windows NT 4.0 Guide Uživatelská příručka stáhnout pdf (Strana 87)

Chapter 4 Using the Microcal Diagnostic Utility 87

Communication Settings

The middle portion of the Status box shows the communication port

(COM1 – COM7), the interrupt request (IRQ), the baud rate, and the

data format being used by the touchscreen controller.

The Parameters field lists the data format as follows:

Parity (N=none, E=even, and O=odd)

Number of data bits (7 or 8)

Number of stop bits (1 or 2)

Video Monitor Information and Help Level

The bottom portion of the Status box shows the video card detected,

the current video mode, and the current help level.

To change the video mode, press F5. You can continue to press F5 to

cycle through the available video modes.

Note:

If you change the video mode, you should calibrate the

touchscreen again. The display area is different in each video mode.

To change the level of help displayed, press F2.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 143 144

Žádné komentáře

Microsoft Windows NT 4.0 Guide Uživatelská příručka Strana 87